Cass asked ... Replacing full bulb housing unit in Neff oven?    |    Pádraig O Sabhain asked ... How to fix Kenwood Slimline Dishwasher KDW45X20 with a F1 Er?    |    keith asked ... How to reset after battery change?    |    Carol asked ... How to remove roller from lawnmower?    |    Ariana Orellana asked ... Code?    |    Click here to ask your question

Whats wrong with my murry 3.5 H.P. lawn mower?

When I pull the start cord gasoline comes out the muffler.
Michael Lance, September 2004
It runs at a low speed even under load. The cauperator connection and spring seem to be ok. I can increase RPM's by pushing the little fan that takes air from the flywheel but it doesn't move on it's own. It seams free and well oiled.

jim perry dj8137@aol.com, November 2004
the diafram is gone in the carb easy to replace

martin, November 2004
carb. is leaking gas into the motor.the float is stuck or has a hole in it if you remove float shake to hear if fuel is inside of it if their is it is bad.float level setting may be off.fuel inlet needle and seat need replaced.sometimes tapping on carb if float is stuck will stop it from leaking.but most likely carb is going to have to be cleaned and worn parts replaced.your oil if a 4 cycle motor needs to be changed the gas leaks into the oil and if not changed will destroy the motor.do not run until gas leak is fixed and oil is changed.

mike w, October 2004