HAVE TAKEN MY MCCULLOCH PETROL STRIMMER APART TO REPLACE A THROTTLE CABLE. BUT I AM HAVING PROBLEMS PUTTING IT BACK TOGETHER AGAIN , A WORK SHOP MANUAL WOULD COME IN HANDY. THE MODELS IS M T 300 X

D F Charlott, June 2005

I took apart my MT300x too last night , take off the engine screws first , then unclip the wires connecting to the starter. Pull the engine out from the driveshaft. Take apart the trigger and thread the Throttle cable through. After its all be done , push motor back into place and reconnect wires. This is where your motor and shaft will get stuck , just turn the motor cyclinder untill it will fit in , remember, the driveshaft is square so it has to fit into the square hole. Once in place , screw in the engine bolts and your done!

Jack, July 2012

yes please

snappy, July 2009

Go to www.jackssmallengine.com click on parts look-up then click on I think parts look-up again. From there you will click on the heading catalogs. Scroll down and click on MTD. Under this heading you will find Mccullock and gas trimmers. Click on that. You should find your model, click on it and there will be you parts diagram. Hope this helps

cholbach, June 2005