I took the timer board out to check what was going on. Cleaned this out with electrical spray - was a bit dissapointed at some of the factory soldering - did a bit of a clean up - still nothing.

Not sure if the unit needs to be reset or if the power off for the 30 mins I was working on it would have done that.

Is the timer / board messed? Anything else I can check before I fork out for a replacement board?

Chaz, July 2008

This is now sorted. Fix it guy came around - opened the lower panel on the front - pipe / filter was blocked. Sorted. €20 later.

Chaz, August 2008

Thanks for the response. I think it does - but will check. Should be easy enough to measure the contact / check if its closing.

Would yours do the same - start with the first cycle and effectively not go to the next (rinse I think)?

Chaz, July 2008

Does the lid close down all the way? I have had to lean on mine to complete the cycles as the lid is warped and the pin doesn't connect through the little hole it fits into.

Jennifer, July 2008