I have Iveco 7.5 chassis cab. There is a pipe on the n/s that goes from n/s front junction block to engine compartment, and it is leaking fluid. This pipe is part of the cab lift system. I cannot lift the cab due to lack of pressure, and cannot change pipe until I raise cab. Any ideas how to manually lift cab?

Thanks in advance

Mike Smith, December 2008

you must connect a pipe running outside the cab tao the cab lock under the cab from the pump this will open the lock then put the pipe onto the ram from outside the cab this will raise the cab .
it is difficult BUT NOT IMPOSSIBLE.

LECKY, December 2008