Ryobi 725r "EZ"...can open partial choke to B but not to C?
I have a Ryobi 725r and am literally pulling my arm off
trying to get it to run fully. I have replaced the plug with correct gap .020; cleaned air filter: new fuel lines; new and correct fuel mixture 32:1. I am able to start it and move the choke to lower B position but am
not able to open the choke to the full run position C.
It will start easily, but dies if I don't set the idle up.
The engine has power but I am unable to figure it out.
It is in practially new condition. I don't know when it was made. I am on fixed income and trying to do it myself. Any help that you could give me would be
greatly appreciated and grateful!!
THANK YOU IN ADVANCE FOR YOUR TIME AND ATTENTION!!!!!!!!!!!

rick, August 2009