i have a sukida sportman sk 125 4000 miles and it will not draw in its fuel from carb. carb float chamber is full float level looks ok carb is clean just done valve clearances had it running for 10 mins after i squirted fuel through venturi but stopped when hot couldnt get started again tappets checked again plug dry even if i choke carb with my hand need help forgot what float level should be may check that again what a hunk of junk

liam, May 2010

does any one know the correct float level for sukida 125 sk sportman

liam, May 2010

the slide goes up and down as it should

liam, May 2010

liam your right they are junk,check this take the air filter hose off the back off the carb and put your finger inside the venturi and make sure the slide lifts all the way up smoothly and comes down again slowish.as these do have a habit of the slide spring fouling up and jamming the slides travel whcih in turn stops air flow and also the main jet cannot operate with the slide needle stuck inside it.

adam bike doctor, May 2010

They are chinese and of poor quality. double check your jets in the carb and settings. Phone your local Sukida.
Get it running sell it and buy a Honda

bb, May 2010