f10 error is a fault on the heater circuit.you will have to access the heating element and thermostats.unplug the dryer and remove the screws from the bulged panel on the back.undo the two screws and remove the heater assembley and take out.you will see three thermostats,take a look at the brown stat in the middle for a small hole on the rear.gently push a pin into the hole you should hear a click.this is the stat resetting.if no heat and error is still apparent after the reset you will have to test the three stats and the element with a multimeter for open circuits .hope this info helps.
ozone, December 2011
