How can i replace a built in vent hose on a whiteknight 447wv tumble dryer as old hose is ripped?

Claire, February 2012

there's a small removable panel at the bottom of the rear of the dryer, take the screws out and rotate the panel up[ and to the right to allow you access the interior. Lie down on the floor and look in under the drum theres 2 big clips secure the vent hose carrier to the exhaust duct, unclip the hose and carrier, fit new hose to carrier and reassemble.( as with all electrical repairs please ensure the appliance is disconnected from the power supply before removing any panels )

Jim, February 2012

or gaffa tape

oh yes its unsightly, but it works a treat.

don't use it if its split where it joins the housing though.

paul, February 2012

its a back panel off job.New hose is supplied with a plastic moulded housing on to clip to front air duct

ck, February 2012