David Dawes asked ... How to recoil the starter spring - Champion R484TR?    |    peter high asked ... How can I set time on my Neff oven?    |    Michael asked ... Mountfield empress drive belt?    |    John Barton asked ... How do i clear the TAM?    |    John asked ... How can I mend my binatone veva 1210 handset?    |    Click here to ask your question

can you help please ,needle hitting metal and break ?

needle breaking ,as when going down is hitting metal plate, also thread does not pick up thread from the bobbin underneath can you help please thank you .. singer sewing machin model 507
marie, April 2015
hook timing out,hook point should pass just above needle eye .approx 2mm, when needle is in upward motion approx 5mm from bottom turning motion. remove bottom cover on machine and loosen screws holding hook drive , set timing as described and secure, test on zig zag and adjust again back or fore if not correct,also make sure needle point is approx 8mm above needle plate for correct travel

johan, May 2015
link Click here to see other fixes for Singer.