Checked filter which is clean.
dryer blowing cold only.
Cleaned all vent pipework as best as possible.

Peter Walton, March 2005

can i fix the dry at home on my own or will it need someone to come out and fix it ??
do i need to replace the 4 wires on the back or keep them the same ones im confusedddd !

jason 098, October 2011

Remove blower/heater cover at rear. You will see two thermostats. Remove the three wire connections and bridge them using a heavy enough electrical wire ensuring that no wire is in contact with the machine. Do a trial run but beware not to burn out the element, so keep a hand on it's casing to feel if it is heating up. If no joy try bridging the second themostat (2wires)
Hope this helps!

Themadfifer, August 2011

Thermal fuse (184 degrees) on black wires of heater element at back of machine. Remove rear silver cover. Disconnect all 4 wires in side machine - wires have thermal covering. Replacfement fuse from maplin - code RA19V - cost 49 pence. Crimp (best ot to solder) new one in.

AKC, April 2005