Replacement belt on bell and Howell 256 auto load ?

Replacement belt on bell and Howell 256 auto load

Bell & Howell Projector repair in California?

Model 1447Z

Bell Howell Autoload 8mm Projector?

My motor runs but it does not operate the projector mechanism, how do I disassemble the unit to get to drive system. I guess it needs a belt.

How can I change the drive belt on my Eumig 610D projector?

How can I change the drive belt on my Eumig 610D projector?

done

Bell & Howell 456A?

The lens is out of focus, and will not rotate to adjust the focus.

How do I open the Reflecta Diamator AF? ?

The sliding bar on my reflecta diamator AF is stuck in the extended position. How do I open the housing to get in and sort it out?

Bell & Howell projector?

Can someone help with a Bell & Howell Projector? I didn't receive a response to my question from earlier this week. Does anyone know how to repair the take up reel on a Bell & Howell super 8 LX20 proj ... more

done

How can I repair take up reel when it doesn't spin?

Hello! How can I repair the take up reel on a Bell & Howell Super 8 LX20 projector? The back reel does not spin. Thanks.:)

done

Take up gears?

The nylon or plastic take up reel gears are worn, apparently and slip so that the take up reel doesn't turn

How do you replace the belt on a Bell & Howell #1421 Super 8 Projector?

How do you replace the belt on a Bell & Howell Director Series #1421 Super 8 Projector

done

Lamp holder?

Were can I purchase a ceramic lamp holder for my reflects diameter slide projector ?

done

Take up reel not turning?

Bell & Howell Super 8 Model 1421 Take up reel not turning when in forward mode so film not being gathered on reel. Projector has not been used for several years but has been stored in air conditio ... more

done

456A no image from film shows?

My 456A does not show the film on the screen. I just get light. I ran without film and there appears to be some type of design on the projected light. I took out the lens and turned on light and it do ... more

Bell and Howell 626 projector - no volume?

I have a Bell and Howell 626 projector. There is no volume, the sound is there but very faint. The volume control is also very crackly. Help please!

done

Bell & Howell Movie Projector 461A?

Auto threads ok. everything seems to work fine, but when it's turned on, the picture frames go by quickly like it's pulling the film too fast past the lens. Framer doesn't help.

Bell and Howell 256 reel arm?

Ok...I just found a Bell and Howell 256. The front reel arm is off and there are 3 or 4 washers, a gear and a clip that need to be assembled in the reel arm. Does anybody know how these are assembled. ... more

How to replace a Bell and Howell 458A Belt?

How do you open a Bell and Howell 458A to changes the Belt? I took the two small screws out on the bottom side of the case that appeared to hold the side case on .... but couldn't remove it. Any sug ... more

gaf 1688?Z no power?

My old 8mm gaf movie projector will not power up. Is there a fuse that I should check?

Need to find a part?

I have a Sears Du-All eight projector that will not thread the film. I believe I am missing a rubber retread for the wheel. Can you help me?

Anyone know where I can buy a Sears DU-ALL 8 Projector bulb?

I am looking for a bulb/lamp for a design 584.92560 Sears Projector. Serial No. 2292303.

done