Hoover, Wind tunnel 2?

My brush does not turn when the setting is at any height and the handle is down Is there a way to tighten the belt? This is a new belt and the old one did the same. This is a Wind tunnel 2 with 2 c ... more

How can I repair an Electrolux Oxygen model po?

On Electrolux "Oxygen" model canister vacuum, there is a motorized power nozzle. The front end of the bottom opens easily for replacement of the roller. The back end of the bottom when opened, will al ... more

Water leak?

vax carpet washer leaking water from back model ecb1spv1

Hoover supreme vac model U5445-900 carpet adjust not work?

why doesnt the carpet height adjust on my model U5445-900 hoover supreme windtunnel work

Dyson dc33 has new belts but won't engage in carpet mode?

I have a Dyson DC33, brush quit spinning. I changed both the belts and it still is not engaging in carpet mode. It work fine on hard floor setting though.

done

Kenmore whisper belt 116?

remind very small plastic wheel on following head

done

Morphy Richards cordless supervac sleek lite?

Morphy Richards cordless supervac sleek lite. It picks up fluff and bits, but when moved, bits fall out.

done

Miele vacuum cleaner- c3 powerline?

I have Miele Vacuum cleaner -- Complete C3 Powerline. Motor speed control is + Maximum and would not fluctuate to minimum Please any help.... doI neen to changer the speed board

done

How do I fix my bissell proheat?

my bissell preheat only spits out water when the lid of the tank is off. any idea what could be off?

done

Where can i purchase?

I have an Electrolux VC-T3510E-1 Model Z1860 and the on/off switch stem has broken off and would like to replace it

done

Why is my water not spraying threw the pipe?

My Vax rapid power is not spraying water threw the pipe to clean the couch its brand used once then stopped spraying water

done

Hoover 0212 Polisher?

The on off switch for my Hoover 2012 model polisher is stuck in the depressed position. How can I free it

Open a ze310?

Does anybody know the proper way to open eletrolux ZE310? Thanks for any help.

done

How to be certain that the vacuum motor packed up?

Our vacuum cleaner would not start. I used a voltage tester pen to ensure the power reaches the on/off switch. The advise of Hwk April 2015 on this site helped me quite well open our 5 year old Nilfi ... more

Henry hoover wont work?

My red n black henry wont turn on lights are on but nothing only use it once aweek only 2 years old what could be wrong ?

How can I fix loose clamps on my Filter Queen?

Directions I have a majestic filter queen vacuum. The clamps holding the top to the body of the canister are loose and don't hold. Is there any way to adjust them? G. Paulson

No steam/water?

My Vax S86 SF CC seems to have usual “no steam” problem. I took out filter and replaced the water tank and expected to see water in the cavity - nothing. Is water being blocked?

Electrolux epic 6500?

i replaced the power button and fulcrum also replaced the power cord now the overtemp lamp is on and it will not run. what did i disturb? i have and electrilux epic 6500sr

How to reset brush roller on dyson dc 41?

how do i reset the brush roller on dyson dc41

done

Vax Rapide Ultimate?

Hi there, I have the vax rapide ultimate, It leaks a lot when operating. I have replaced the clean water tank for new thinking it was the seals, it isn't. It leaks from the underneath. I have ta ... more