changing water impellor?

what are the steps required to change the water impellor on the suzuki dt5 outboard motor?

How do you remove tamper caps on high and low adjustment screws on my 1200g?

How do remove the tamper caps on high /low adjustment screws on my GP1200R waverunner 2001 (mikuni carburetor 44mm)?

fixings aswell?

i am looking for a boat cover for a microplus 500, with fixings,

carb. problems?

I installed a carb. kit in my 40HP Johnson(1967) and it still pours gas !

done

XL750 Code Problem?

I have a XL750 as well and tried to reset the code by unplugging the blue wire in front, holding down the code button for 3 sec.....then when i input the 4 diget new code (A, B, C...etc) i get a "erro ... more

why does engine start on full thurst then cut out when taken off full thrus?

why does engine only start on full thrust, but when taken of full thrust cuts out?

done

how to remove u joint?

u joint how to remove

done

On start up the transmission runs in reverse? YSE 12?

Transmission runs in reverse even though the selector handle is in neutral. When shifted into forward works fine. When shifting into reverse it responds but slowly. Is there a way to adjust the clutc ... more

i have a 1994 75hp yamaha outboard the motor dont tilt up or down?

how can i replace the tilt trim motor?I disconnected the 2 leads 2 the motor and applied 12vdc to it but it just makes a humming noise.

microplus 501?

what is the safe depth for a microplus 501

done

Safety knowlege?

What is the safe depth for a microplus501 on the move.

done

1996 wave venture wont turn over?

new battery new fuse still no action

Waverunner Body Work?

I have a 2009 Yamaha Waverunner, FX Cruiser SHO. I am trying to repair two large (10") holes in the upper body shell. Can this be repaired with a normal type fiberglass repair material? Or is somethi ... more

Does any one know of incinerated toilets?

I would like to buy a toilet that reduces to ashes the waste any information gladly receivedv

when my jetski sits for any period of time the battery goes dead ?

its a 97 yamaha GP760. HELP!

I have a crack on the bow of the gunwale of my laser dinghy?

have a crack on the bow of the gunwale of my laser dinghy and i am unsure on how to fix it any help would be apreciated.

Yanmar L70 pull start freezing up mid pull after Decom lever engages?

Not sure if this is the rite place to ask but I'm at my whitts end looking for an answer to my problem. I have a Yanmar L70V6-L pull start with a decompression lever. It's easy to pull with the Decom ... more

done

how to replace mirror 96 seadoo xp?

how do i remove the old mirror on my 96 seadoo xp

no spark on near new outboard?

out board that is almost new cond was stored properly for a couple of years. Now has no spark ? what might be the problem and if it is possible that magneto or coil to lose there magnatism or spark c ... more

merc 9.9?

have outboard that is new been stored afew years now has no spark ?