home Fix label Power Tools label_important Drills category DeWalt

how can i remove the keyless chuck on a DeWalt958 type3 cordless drill?

I have a DeWalt958 type3 cordless drill. The keyless chuck is rusted so it will not loosen or tighten up . How do I remove it

debby, May 2008

home Fix label Power Tools label_important Drills category DeWaltdone

wd40 all over it,let it do its stuff, ie penetrate, then open chuck (use forward and back to free it up while holding chuck - be careful) and remove left hand threaded screw inside, remove chuck. clean it up and degrease or buy a cheap new one!!!!!

david harman, May 2008

if u can open the chuck up, and look down it u should see a screw. undo this, then the whole chuck needs to be unscrewed from the drill. hope this helps.

steve, May 2008

link Click here to see other fixes for DeWalt D958.

Fix Fault - Power Tools

home label Power Tools label_important Drills

home Fix label Power Tools label_important Drills category DeWalt

how can i remove the keyless chuck on a DeWalt958 type3 cordless drill?

I can answer this question...

how can i remove the keyless chuck on a DeWalt958 type3 cordless drill?

I can answer this question ...

how can i remove the keyless chuck on a DeWalt958 type3 cordless drill?

24 v battery charger ?

Hilka drill?

where can i buy a cut out switch for my power devil table saw pdw 5012 the ?

Smoking fromm commutator?

How to fix a Challenge Xtreme cordless drill CD1218J?

12v?

power pro charger red light gone out?

flat battery?