i can help u , then u can help me.
1-take lid off top off machine
2-take a note of the now visible wiring ot the rear of the front panel ( then can u please tell me where the wires go coz i lost my diagram)
3- leaving wires intact, just pop off top front panel
4-pop off bottom panel
5-remove all visible screws that hod the main door panel, then panel will prise up to the right. at this point u will need ure diagram as wires will start to pop off
6- remove old belt
7- THIS BIT IS A NITEMARE- FIT NEW BELT ROUND THE BODY OFF THE DRUM. then u have to force the drum down,and connect belt to motor. u need 4 sets of hands for this
8- wipe blood from your elbows, and kitchen floor
9- spin drum to check that belt is inline with motor
10- refit is reversal of above, but make sure that u also refit black duct pipe into machine---unlike what i did-
11-please please please tell me where the wires go on back of timer unit??????
total job took me 90 mins.
lost my wire, August 2008
