Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Scantronic 9000 series reset?

Decorator took remote keypad off wall and upset alarm. He didn't know eng code so messed about and now the display reads - and only the power light is lit.
I know the eng. code but nothing haqppens when I enter it. Can anyone help.
Melvin
Melvin, September 2008
Try this - http://www.eurotech-security.co.uk/manuals/INTRUDER/9100USER.PDF

Richard, October 2008
Hi Melvin;
The Engineer's Reset is normally as follows:
1. Press '0' followed by 'Enter' (or '#').
2. Enter Engineer's code (default: 7890).
3. Press '99' followed by 'Enter' (or '#').

Hopefully this will sort it if you haven't done already.
Good Luck.
Simon

Simon Lind, September 2008
link Click here to see other fixes for Scantronic.