David Dawes asked ... How to recoil the starter spring - Champion R484TR?    |    peter high asked ... How can I set time on my Neff oven?    |    Michael asked ... Mountfield empress drive belt?    |    John Barton asked ... How do i clear the TAM?    |    John asked ... How can I mend my binatone veva 1210 handset?    |    Click here to ask your question

HELP!!! Siemens RDH 10 RF Thermostat ?

I have Siemens RDH 10 RF Thermostat but have lost the instructions and am not sure how to reset it so that it works. My heating is not coming on but the hot water works. Does anyone have the instructions for this thermostat?

Many thanks,

Katie
Katie, September 2008
My unit is turning down when I turn the wheel up & visa versa

Val T, November 2022
How do change the battery

mags, January 2016
OMG what a great site. You have just saved me and my kids a freezing cold night at home and an expensive call out charge tomorrow. So easy when you know how

Clare, December 2014
Hi,

My thermostat is communicating with the wall unit, but it's not turning the boiler on. All the lights work and it clicks when I turn the temperature dial. I've successfully reset the thermostat to communicate with the wall unit but it still won't turn the heating on. The boiler is heating the water. It was working fine this morning. Please help,it's minus 1℃ outside and I'm freezing 😭

Nick, December 2014
No lights coming on to wireless siemens receiver

Arvind, December 2014
Same problem as below, multiple resets and relearns. Two hours and nothing. About to throw in the towel when I hit it reasonably hard on the front of the case…Bingo!

Oliver, October 2014
I have a Siemens RDH10RF thermostat and the receiver unit is not causing the heating to come on. I have changed the batteries and the heating still not coming on. Can you help?

Jennifer, December 2013
I have tried to reset more times than you can imagine hot water ok but no heating help

Jonny, October 2013
Worked for me too, thanks!

Hong Kong Phooey, March 2013
i tried all of above nothing is working no lights at all on receiver unit

BJ, December 2012
I just tested our system and the sender (thermostat) wasn't talking to the receiver (wall unit bit). I did a reset several times, didn't work.
Finally realised the system had been turned off (on the clock) for the summer. I clicked the little slider within the clock onto the ON position and bob's your auntie: heat :)

2Sheds, October 2011
Tried the above but does not seem to work I have a red light on the receiver, transmitter will not pick up room temperature argh!

Andrea, September 2011
Thanks so much for your answer - and it was free and took less than 30 secs to put right!!! The weather's warmer today so don't even need the heating now!!! Could have done with it last night! Thanks again!

Ruth, June 2011
Many thanks for this, it's a lifesaver!

Will J, March 2011
Thanks John - it worked for me too. Can't understand why the information manual on Siemens web site doesn't show this crucial information!

Mark G, February 2011
worked for me! cheers

john, November 2010
press set on the wired in portion then remove the covers on the back of the thermostat. under these two covers you will see two buttons test and learn. press learn this will lock the two units together.press test this will turn the boiler on press test again this will turn the boiler off

Belly, December 2008
link Click here to see other fixes for Siemens.