can anyone help? some of my v.m channels come up no signal but the description is there (about 5 out of 220 or so). Everytime i put in new codes the same channels have no signal. I had them up until about 2 months ago. Any ideas?

danbros09, November 2008

hello danbros09,
The only thing I can think of at the moment is when you re-scan whether it be an Auto-scan or Manual- scan, have you deleted these channels with no signal, cause if you don't, proper working channels on same frequency will not be found. Hope this is helpful. Good luck. Best regards Sathawk216.

Sathawk216, November 2008