I've just turned my new Carl Lewis MOT566 treadmill on and it just keeps bleeping and shows E01 in the speed box. Could you please help me get this resolved?
Dose any one know if u can just buy the emergency stop magnet for tthese please x
Pauline Vaux, September 2014
cable on the back of my Carl Lewis treadmill was accidentally pulled off by my daughter, my husband is going to fix it but wants to know if there is a page on how to
Kennedy18, May 2014
buy a new one
harry, February 2010
from where i can get a madnetic cord for the machine..
AA, July 2009
glad it worked! did you need new circuit board?
phil, June 2009
phil, thank you very much! had the e01 problem and your answer solved it! :)))
Mac, May 2009
yeah, when magnetic cord removed error 007 comes up
chris, April 2009
new circuit board fitted - problem solved for me
phil, April 2009
Hi- just had same problem
error e01 means an electrical malfunction.
this could be in any of the connectors,
you need to check all terminals out.
remove right handle and inside you'll see where the wire comes up from the power source - make sure the joining terminals are tight.
remove the screw from under the sensors on handles - ease out sensor unit with a flat screwdriver - check terminals are tight undeneath - do this both sides.
Look under machine - see where cables lead up into handles - check the connections here -
look behind display unit - check connections.
remove black plastic motor cover (unplug unit from wall first) - two screws each side -
on the circuit board you will see two pairs of red/black power leads - push tight -
there are five other removeable white connectors - some have glue on them - again check tightness
if none of this works (as in my case) carl lewis fitness say it's probably circuit board - new one costs £50 delivered - easy swap 0845 603 4120
mine is on the way....
good luck
phil, March 2009
Have you got the magnetic emergency stop plug fitted to the console the machine will not operate without this
