Fault was caused by a blocked drain. Drain and dishwasher now clear but still machine is indicating E4 error code.

How do you remove error code and bleeping?

Kenwood KDW243A Dishwasher

Elaine Oliver, February 2009

turn off power switch make sure door is shut, hold delay,prog,and start buttons while turning power button on should flash up 66 on display briefly, turn off power switch and unplug leave for 30 mins and switch back on this reset mine, make sure before you reset you have removed most of water you can then start new programme by holding start button for 3 secs good luck

sach, February 2009