My Beko dishwasher appears to think that there is water inside it as the drain pump is constantly running. If i leave it switched off over night and restart the program it starts allowing water in for a few seconds and then goes back on to the drain cycle. It doesnt allow any more water in therefore preventing the cleaning cycle to continue. I am struggling to find a service manual therefore unable to decide what part is at fault.
hi,
try the float valve fixe to the base plate at the bottom of the machine,It should have two plastic pipes on the side of it.Constant draining usually means it is stuck up( its mada of polestyrene)
Martin Fox, September 2009
there is water in the base.tip appliance on its back and let ALL the water run out.this will reset the antiflood switch.now retry.if the base fills with water again you have a leak somewhere inside the cabinet.
