Sandy asked ... Replace vertical gear on Singer Fashion Mate 252?    |    Blaablaa asked ... How can I fix?    |    pete asked ... Flymo 330 turboglide?    |    keith asked ... Fuseboard( s) location of renault trafic t1100 1993?    |    Janet asked ... Neff B1641 door not closing at top?    |    Click here to ask your question

My Peugeot 406 2.1 TD is boiling?

R reg 406 2.1
Original fault: Wednesday in town the car overheated for my wife and coolant poured out on the floor. Not stuck in traffic, no real reason to overheat. She even noticed it was getting warm so put the heater on - happened in McDonalds drive-thru !!!
Got the car recovered home, found bottom hose had blown off so replaced o-ring and refitted hose. Filled with water ran car up for an hour fan cutting in and out as it should... all good - temp under control.
Decided not to use car until I'd replaced water with antifreeze so yesterday I drained system again and replaced with antifreeze, all bled through following Mr Haynes instruction, however on testing, the temp guage got to 90 - no fan cutting in and car boiled again, this time blowing top hose off and dumping coolant to floor. Any advice would be greatly recieved.
Big Bloke, August 2010
head gasket gone mate i had same problem ...costly

claire x, August 2010
when your motor is blowing hoses off,there is a lot of pressure there,guessing it is probably head gasket

wickham, August 2010
link Click here to see other fixes for Peugeot 406.