Open the hood and prop it up. In the very front corner of the exposed area is a Torx T-20 head bolt, not really recessed, but in a hole in the cosmetic treatment. Loosen and remove it. It takes quite a few turns and it's unusually long.
Look to the inside of the turn signal lens, within the grille, for a similar T-20 holding a tab, loosen and remove.
On the outside of the vehicle, between the turn signal lens and the headlight housing is another T-20 screw.
With all three removed, the lens assembly slides slightly outward, and then slightly forward for access to the bulbs. Turn each bulb a quarter turn counter clockwise (unless you're viewing a digital clock) and they release.
I discovered that my bulb was not blown, and only needed to be removed and replaced to "wipe" the contacts and work again.
Reverse the above steps to re-install.
fred, April 2007
