home Fix label Security Systems label_important Home Alarm Systems category Scantronic

Scantronic problems 9800+?

Hi all I have a scantronic 9800+ showing a t9 fault ?? I caused this today while decorating , any clue how to reset the system?? User code doesn't work ??

Thanks in advance

Jason

Jason
April 2012

Jason, April 2012

home Fix label Security Systems label_important Home Alarm Systems category Scantronicdone

but find the tamper fault first cut , cable ?loose cover on an pir ?

gts, April 2012

if its prog for engineer reset,then you have a propblem
try key in 07890,then 99 enter

gts, April 2012

the panel is smarter than you,its telling you where the fault is,check zone 9 for tamper ,its not hard,is it ?

gts, April 2012

link Click here to see other fixes for Scantronic 9800.

Fix Fault - Security Systems

home label Security Systems label_important Home Alarm Systems

Fix Fault - Security Systems

home label Security Systems label_important Home Alarm Systems

fixfault.com for free repair help, information and advice.

How can I fix my Risco Gardtec 300?

How can I fix my Scantronic 9600?

How can I fix my Paragon Plus?

How can I fix my Accentra G3?

How can I fix my Accenta G4?

home Fix label Security Systems label_important Home Alarm Systems category Scantronic

Scantronic problems 9800+?

I can answer this question...

Scantronic problems 9800+?

I can answer this question ...

Scantronic problems 9800+?

Accenta G4?

I have a problem with my house alarm system SYSTEM: EUROSEC?

Trying to change battery on door connect?

How can I upgrade my Scantronic 9827 home alarm?

Gardtech 800 Alarm?

How can I reset a Scantronic 9427?

How to turn of tamper alarm on Logic Six house alarm?

Veritas Alarm panel unable to set user code?