when starting the machine, the fill process stops/starts.
i have replaced the board and tried new face panels.
i have also replaced the board under the washing machine which is attached to the windings.
any ideas? a service manual would be awesome if avaliable for this model

kalmedia@westnet.com.au

kalmedia, October 2006

i found on my parents f+p that the out of balance switch located under the main power control board was corroded over time due to condensation. It was conducting just enough with the built up corrossian to trick the controller that the tub was out of balance. Every process would stop start. Once cleaned it worked fine.

dave, November 2006