Dan asked ... Why is Google Keep so slow on my iPhone?    |    dave s asked ... Transmission not working?    |    Tom asked ... Replace rear right door upper right latch cable - high roof?    |    ian asked ... Vaillant timeswitch 150 analogue unit (clock stopped?    |    Art Cour asked ... How do I get engine cowling off to find gas leaking?    |    Click here to ask your question

NECHT WQP8-9325?

lOOKING AT THIS WEB SITE I GUESS I'M ANOTHER DUPED GUY!

HAD THIS WITH A KITCHEN 2 YEARS AGO, THE PROBLEM: IT STARED HAVING A SMALL LEAK ON THE FRONT CENTRE AND RIGHT WHEN VIEWED FROM THE FRONT, THEN YESTERDAY IT WOULD NOT WORK.
PRESS THE ON/OFF BUTTON AND IF YOUR QUICK YOU MAY GET TO THE THIRD PROGRAMME SELECTION BUT IT MAKES NO DIFFERENCE THE MACHINE JUST GOES BEEP! BEEP! FOR A FEW MINUTES AND STOPS, AT THE SAME TIME IT SOUNDS LIKE IT'S TRYING TO PUMP OUT WATER, BUT THAT ALSO STOPS AFTER A FEW MINUTES.
i'VE DISCONNECTED THE OUT PIPE AND CHECKED FOR ANY BLOCKAGE BUT NOTHING APPARANT.

SO HELP ANYONE?
MIKE, November 2006
Hi i have a problem with this dishwasher, it seems to go through all the program etc but does not get any thing clean.

Debbie, January 2018
hi i have the dishwasher above only really used it three times how and what button do you press to empty the water what is still in the bottom.

its only abit but it will start to smell

HUGHES, December 2014
Hi Mike,

I have the exact same problem, I have found the cause to be water leaking from the door seal into the controls/ electronics. It may be due to a poor door seal or a worn latch mechanism that isn't holding the door shut & sealed. I have removed the panel & dried up all the water & it goes again. Another problem may be a sticky float tip the dishwasher back to free the float & clear it. If you find its stopping half way through a wash & tripping your MCB's on your supplies it is more than likely to be water in the electronics. If you have any luck let me know I am struggling to find spares, I will let ya know if I'm successful in my repair.

Cheers

Trev J

Trevor Jackson, June 2007
Thanks for that, the manual mentions a flooding control which brings the pump on. Perhaps that was what caused it. I just tipped the machine forwards so that the water which was inside the cabinet drained away and everything was fixed. Thanks again.
Martin

Martin, February 2007
my dishwasher is the same make. i could not get on a proggram it kept bleeping .and flashing e4. so i took it outside and tiped it upside down drained the water of and low and behold its now working. try it

sue, November 2006
link Click here to see other fixes for Necht.