home Fix label Security Systems label_important Home Alarm Systems category Burg

I keep getting error "burg z07 alarm back door" when setting alarm?

How do I reset this to ensure this sensor on door works.

Julian, January 2013

home Fix label Security Systems label_important Home Alarm Systems category Burgdone

Yep does sound like a sticky reed :)

Try tapping it GENTLY with screwdriver handle,tap it several x and if the circuit closes then you can set the system,

Better off replacing the reed though cos it's likely to stick again.

e manno, January 2013

check the door sensor,your alarm is telling you its open circuit

gts, January 2013

Shut the back door then.

Alarm, January 2013

link Click here to see other fixes for Burg Z07.

Fix Fault - Security Systems

home label Security Systems label_important Home Alarm Systems

Fix Fault - Security Systems

home label Security Systems label_important Home Alarm Systems

fixfault.com for free repair help, information and advice.

How can I fix my Melcom ST4500?

How can I fix my Paragon Plus?

How can I fix my Scantronic 9500?

How can I fix my Scantronic 9752?

How can I fix my Micromark MM23084?

home Fix label Security Systems label_important Home Alarm Systems category Burg

I keep getting error "burg z07 alarm back door" when setting alarm?

I can answer this question...

I keep getting error "burg z07 alarm back door" when setting alarm?

I can answer this question ...

I keep getting error "burg z07 alarm back door" when setting alarm?

CEF AP28 alarm issue?

Home burglar alarm?

Veritas 8?

How do I resolve the Bell Tamper?

Optima xl6?

Melcom ST4500 Jaytech?

Alarm not going off?

Accenta G4?