I just replaced my old ragged belt with a new one...suposedly of the same length. Problem is that it is too tight. I can't find a service manule after 8 years and can't figure out how to loosen it. Any help?

Trevert, September 2007

I just found out how to tighten the tractor drive belt today so I think I can help you. When you replaced the belt you may have noticed that one of the idler pulleys is mounted in a slot on the bottom of the tractor. Loosen the nut holding the pulley on and slide the pulley in the desired direction to loosen/tighten. I wish I had know this before I was told to by a new belt ($27+) because the tractor movement was lagging/surging.
Of course since your post was 2 years ago you probably figured this out already but maybe this will help someone else.

andyboy, June 2009

Hi trevert...i don't hav an answer for your problem...could you give me the part number of the belt your trying to put on..i have no manual either and every time i go out and try to get a belt they are way to long.

Thanks

Walt

Walt, October 2007