5hp norlett rotorvator crank issue?

Have just brought a 5hp norlett rotorvator I knew there was a issues in the crank case but after all the sodding bolts, have found that the top chain has snapped and has mangled the middle sprocket a ... more

Trigger assembly?

I have a jcb m24 hedge cutter and the trigger assembly is in bits and I am bot sure where to put the springs for the trigger to bounce back.

done

Kew hobby presser washer?

How do you take the top cover off washer have removed all bolts and screws but still unable to remove

Replacing broken cutting head to FRT 450 A1?

I have a new cutting head(Pt. No.14) but cannot remove the defective one. I have stripped the motor cover but do not know how to reach the retaining nut joining the cutter head to the motor. Can anyon ... more

how do i fix my prq 16000 pwa please?

In use the water gushes out of the handle so water pressure coming out of the wand is very low and therefore doesn't clean. Many thanks

done

flymo l300?

ive cleaned carb replaced diaphragm and will only run ok on high revs,it wont idle and keeps cutting out.i havnt replaced inlet manifold gaskets!could this be the problem maybe sucking in air????I don ... more

Where can I find a user manual for a florabest 500/8 trimmer?

Where can I find a user manual for a Florabest 500/8 grass trimmer

done

How do I drain root tiller crankcase?

I inadvertently put motor oil in the crankcase instead of the engine. It was dusk and I didn't see the correct plug. The yellow engine oil plug is just below the gray, plastic crankcase plug. How do ... more

done

challenge hedge trimmer not charging?

challenge hedge trimmer not charging

done

fixing florabest fht 600b2?

the motor rotates and the blades are not moving.What' s the problem and how to fix it?

done

Replace tines on Power Force Lawn Rake?

Need to replace tines on lawn rake. Removed roller assembly from machine but do not know next step to remove tines from it.

Front drive cog for belt?

The cog that holds the front belt has has worn away, where can I get a new cog

done

Hammer drill rewire?

I have a JCB hammer drill HD 1010 with worn mains cable. I have stripped back the old and like an idiot didn't note the neutral and live. Could you please help?

done

how do i get a spark at plug?

help my 354McCulloch mower wont start, fuel ok, no spark at plug, do i need a new ign coil

done

champion red pressure washer?

pump makes a burring noise on start up

done

Can I get a new selector switch for Homebase Garden Vacuuum an blower ?

The selector switch That switches between vacuum and blowing has broken. Model number bva 2400 It was bought in 2009

Troy bilt electric cultivator works intermittently?

Troy bilt tb154e electric cultivator assembly switch I took the assembly apart but can't figure out how to seat the spring. Anybody know how to reinstall? The Rosenberg part is to expensive-$130.5

gearbox problems?

westwood 1200 gearbox stiff to change from reverse to forward gears

how can I fix the pull rope on a weedeater FeatherLite?

the pull rope will not come out when I try to start it

Bosch AHS 4-16 Hedge Trimmer stopped working!?

My Bosch AHS 4-16 hedge trimmer is a few years old but never given me any trouble until yesterday. I had cut half of my hedge when all of a sudden it stopped working. I thought maybe the blades had j ... more

done