how can i fixmy motocross boots?

how can i fix the heel on my motocross boots

gearbox noisey on motocaddy s1?

can you oil or clean inside gear box

Why is my cross trainer making a noise?

We have a Andes 150 cross trainer. Had it for some time. Recently when we increase the level of excercise the cross trainer is making a noice. How can we fix this. where can we find a professional who ... more

etiger tredmill ?

it has come up with a reading of eo on the timer n stopped working ?

York Cross Trainer x202, power supply keeps turning off?

York Cross Trainer x202, power supply keeps turning off part way through a programme or in the middle of a fitness test. either turns off and back on again no issue, or turns off and back on but the ... more

the running belt wont stay in the middle?

cannot get the running belt to stay in the middle, keeps going to the left and is damaging itself, i did loosen the belt with allen wrench as per instructions to lubricate belt but it just wont go bac ... more

done

How do i fix my trimline 2400.1?

My trimline treadmill is showing an error code-0? Why is it doing this and how do I reset it? It is a model 2400.1. 10AMP HZ60 AC 115 and it serial # is 81020182. 1998 model

I have a error code E1 on my as01 new fitness treadmill ?

The belt won't turn but the consel works fine

the plastic key that starts my tx335 treadmill waslost?

How do i start my tx335 treadmill, i dont have a manual and the plastic key was lost in a move.

how can i fix my sportcraft dartboard?

The one wont mark whole in circut panel

mocadgolftrolley tm2?

wire frompotentiometer trapt in fold down handle, both wires were striped of insulation and joined together, no signs of overheating,have reconnected, there is still no sign of life when the potensiom ... more

Where does a certain nut and washer go? Orbitrek pro form elliptical?

A nut and washer fell out of the bottom of my machine while using it. How can I find out where it goes and to put it back in?

done

removal of front wheel motocaddy s1?

How do I remove the front wheel on my golf trolley

screen not working?

i have a treadmill that belt works but have no time or distance on it the number board is not working but have lights on it

Intermittent fault with motocaddy S1?

After a few yards the trolley loses power and just about goes at crawling speed with no real power. Lifting the driven wheels off the ground and lowering back down the speed and power returns for any ... more

done

Help! My pool pump is leaking?

My pool pump is leaking, I have replaced the washer but not sure what else to do. I'm not sure if a pipe has a crack or what to do without replacing the whole system.

Short Battery life Motcad 3?

18 hole battery only last half the round. Purchased new battery, worked ok for a while now have same problem. had batteries checked they are ok. What could be dragging the batteries down in such a sho ... more

Andes 150?

My Andes works on manual and moves along to the end. However when set for programs it starts then cuts out as it is supposed to move up to a heavier tread. I have tried pushing in the ribbon connector ... more

how can i fix electric golf trolley?

Recently had problems with controlling the speed of my golf trolley (mocad). replaced switch, gear box and problem the same. finally replaced controller and the problem was resolved for about 6 weeks. ... more

done

ultracaddy light controls?

Can anyone advise me how to understand the light control on the handle .Green,Blue,Red ?