Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Synergy 2110 - handset won't link to base?

The smal antenna symbol on the screen of my 2110 keeps flashing (no link to base) If I unplug everything and reconnect after a minute it will make a connection but it does not stay and flashes again after a minute or so. I have tried the "hard reset" by pressing and holding PAGE as I switch on but this doesn't do anything. HELP
Codders, June 2005
I have had the same problem and I tried JP's advice and it cured the problem.

Stan Featherstone, October 2005
FORGOT TO MENTION WHEN YOU ENTER 0000 PRESS THE OPTIONS BUTTON THEN WAIT,THIS SHOULD FIXIT,IT DID FOR ME.

JP, July 2005
HOLD DOWN PAGE BUTTON ON BASE UNTIL IT FLASHES THEN ON YOUR KEYPAD PRESS OPTIONS THEN 5 THEN 1 WAIT FOR A SERIES OF BLEEPS IT CAN TAKE A WHILE SO BE PATIENT THEN WHEN YOU HEAR THE BLEEPS TYPE YOUR PIN# USUALLY 0000 UNLESS CHANGED.

JP, July 2005