how can i set my alarm and give it a new code scantronic 9448+?
ive cut some wires which set my alarm off. i connected the wires again and replaced a fuse but i cannot set my alarm anymore. is there a factory setting code .nothing happens with my code
i am asking you now if i knew the answer i wouldnt ask you this question
jesse, April 2012
factory defaults ? start new instalation guide page 28,restoring factory defaults .then start from scratch good luck.
graham [in greece], February 2008
key in 6 then arrow[bottom right on key pad] then existing user code ,then same code again,[you should hear 2 beeps],then new4 digit code [and should hear another 2beeps] your user code has now been changed.
