home Fix label Power Tools label_important Drills

How do I remove the drill chuck and repair it? #7935 type 3, 3.6 amps ?

I have an older 1/2" Black and Decker 2 speed hammer drill. The chuck is partly open but won't budge either direction. It's stuck in approximately 3/8" diameter opening. My questions are, how do I remove it, can chucks be repaired and if necessary, can I purchase a new chuck for it?

"Jack" Palmer, December 2008

home Fix label Power Tools label_important Drillsdone

hi jack,if you look in side the chuck you should see a phillips screw this has a left hand thread remove screw then unscrew the chuck right hand thread may need some force.best of luck

steray, December 2008

Fix Fault - Power Tools

home label Power Tools label_important Drills

home Fix label Power Tools label_important Drills

How do I remove the drill chuck and repair it? #7935 type 3, 3.6 amps ?

I can answer this question...

How do I remove the drill chuck and repair it? #7935 type 3, 3.6 amps ?

I can answer this question ...

How do I remove the drill chuck and repair it? #7935 type 3, 3.6 amps ?

power pro charger red light gone out?

How to fix a Challenge Xtreme cordless drill CD1218J?

need a new battery?

where can i buy a cut out switch for my power devil table saw pdw 5012 the ?

Power Craft Bench drill DP500?

12v?

can electric drill be repaired?

challenge drill?