1 hour ago Carol asked ... How to remove roller from lawnmower?    |    Ariana Orellana asked ... Code?    |    Lynnie asked ... BT Studio 4500 cordless telephone?    |    David Dawes asked ... How to recoil the starter spring - Champion R484TR?    |    peter high asked ... How can I set time on my Neff oven?    |    Click here to ask your question

Clio Code?

I have entered a code for either the radio or immobiliser, I entered it quite a few times. The last time i entered it i could't try it anymore. and it just says code

Do you have a certain amount of times before you can't do it anymore?
wes, September 2006
herro

jj, February 2010
lost car handbook no code for radio can you help please

iain tomlison, April 2009
Wes,

Try this to reset the immobiliser:-

Answer 1: By disconnecting and removing the battery and then replacing it, you activated the anti-theft device in your car. If you arm and disarm the anti-theft device, it should reset. If this does not work using the remote, try locking and unlocking the driver side door with the key.

Answer 2: Try locking and unlocking the rear hatch. This could reset your security system.

Answer 3: I removed battery from car to charge it. Upon returning battery to car, alarm activated itself. The car dealer told me to turn ignition switch on and off 5 times, to reset the alarm.

Answer 4:Try unlocking the drivers door with the key, which may disarm the alarm system.

If none of these work then post your question on this site, for assistance:

http://www.2carpros.com/topics/alarm.htm

Regards

Garry, September 2006
I have just found the code for my radio and it workes but my car still won't start. is this because i need a different code for the immobiliser?

Now that i have put in the radio code, i don't get any message telling me to enter the immobiliser code. if that makes sense

Wes, September 2006
Wes,

Usaully your allowed 3 times, and I think you may have entered the code incorrectly.

Disconnet the car battery by removing the positive cable only and leave it for 30 minutes. After 30 mins replace the cable back and try again using the code correctly.

Hopefully your problem will be solved.

Regards

Harry

Harry, September 2006