home Fix label Heating label_important Home Heating Systems category Murco

How to lower the pressure in my boiler?

The pressure on my Murco FEB24ED boiler has risen to 3 and is in the red zone How do I release/lower the pressure back to 1.6

B Whybrow, December 2012

home Fix label Heating label_important Home Heating Systems category Murcodone

Go round and bleed the air from some rads or let some water out

bryan, December 2012

you set the water pressure when cold.
1.6bar seems a little high but if that is what the instructions say.bleed rads or use drain of point to reduce pressure

A1, December 2012

link Click here to see other fixes for Murco FEB24ED.

Fix Fault - Heating

home label Heating label_important Home Heating Systems

Fix Fault - Heating

home label Heating label_important Home Heating Systems

fixfault.com for free repair help, information and advice.

How can I fix my Baxi Bermuda?

How can I fix my Siemens RWB7?

How can I fix my Halstead Hero 50?

How can I fix my Worcester Greenstar?

How can I fix my Halstead Ace?

home Fix label Heating label_important Home Heating Systems category Murco

How to lower the pressure in my boiler?

I can answer this question...

How to lower the pressure in my boiler?

I can answer this question ...

How to lower the pressure in my boiler?

Greenstar 25 combo boiler?

Fan tries to run every 15 seconds then stops immediately?

Reset my worcester dt10rf programmer?

Firebird super Q 50/82?

Siemens RDJ10RF thermostat problem?

How to fix my fireplace?

How do I work my Storad storage heater?

Advice?