I would like too know how to get inside my sky remote without damage

John, January 2013

Good observation Geoff - thanks

Peccavi, January 2013

Peccavi has obviously never taken one apart before.
Remove batteries and remove the two screws you can see. There is a third one behind the black plastic head at the top of the remote . Squeese the two curved spaces inwards and the plastic cap should pull out. Behind it is the third screw. If you haven't got the small star head screwdriver, try a small flat bladed one but make sure it is a good fit.
You can now remove the back cover.
The PCB is also held by a screw of the same type as the cover.
Remove the PCB, then the rubber button templates and you now have the RC in pieces.
The only reason you will need to strip it down like this is to dry it out after some clown (my son) drops it in the sink full of water. If this has happened to you then you are in luck. Once the water and damp is removed from the inside of the keypad it will work a treat. But if it is a broken PCB buy a new one.
Good Luck!

Geoff in Wales, January 2013

You are too big to even think about it - Ho-ho-ho.

More seriously - if you need to ask how to access the electronics it's doubtful that you would do any good if you could open it up for inspection.

When my Sky remote failed I bought a new one - the only issue was entering a four digit code so that it would also work the TV.

Amazon sells them for £7 upwards ... Supermarkets too.

Anyway - if you remove the battery compartment cover you will see two very small cross-head screws - undo these to get to the inside...

Good luck...

Peccavi, January 2013