Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Sounder wiring help!?

Hi I've got hold of a HKC alarm panel with intentions of replacing it for my veritas 8C.the existing bell box is a backlit pyronix deltabell plus,which has different wiring.does anyone have a wiring diagram as the HKC manual doesent cover the pyronix,so iam at a loss on how to wire panel to bell box.

Any help with wiring or better a diagram would be appreciated.
Thank you from Bob Armitage from Osset., December 2013
Top man Alarm then use PGM for ENG HOLD.

You know your stuff matey :) :) :)

e manno, December 2013
Why OP4 to strobe?
Just use the Stb-

Alarm, December 2013
This should get you started,so panel to sounder as follows:

EXT BELL to +

SAB HOLD to -

EXT BELL - to BELL

PGM OP4 to STB

TAMP RTN to BT

SAB HOLD with 4k7 fitted to BELL -

At sounder link TAMP to 12v -

There's two TAMP terminals on the sounder the second one down is the TAMP RETURN!,

Remember the HKC's are EOL's so use the resistors provided with the panel.

That should get you started,also if you use the engineers hold off it's an OV trigger.

e manno, December 2013
:-) :-);-)

gts, December 2013
Give him credit gts he did loose the veritas :)

e manno, December 2013
dump the lot friend buy decent gear

gts, December 2013
link Click here to see other fixes for Veritas Plus.