Eurosec pr5208?

Eurosec pr 5208 remote keypad, how to reset check kp tamper? I re-positioned the keypad with the voltage present (12v) now will not reset.

Re: Eurosec keypad PR5208 Rev 1.0 time delay?

We moved into our home 2 years ago and the alarm keypad is in the kitchen. Is there a method to lengthen the time delay on the setting/ unsettling of the system as currently we have to make a DASH fro ... more

done

How can I fix my Eurosec PR5208 Rev 1?

Following the electricity being off the alarm panel is showing !!!!check!!!! It won't allow me to reset it, what can I do?

done

eurosec alarm pr5208 rev 1.0?

How can I change my new code number.

done

Change set code on Eurosec pr5208?

Moved into house I do have a code that works but it's the previous owner and I need to know how to change it

How Long will alarm go off?

Hi all Moved my keypad to my house alarm earlier- Alarm keypad : eurosec pr5208 unfortunately ive lost the resistor between the two 12v connections so the alarm is going off and theres no way i can ... more

done

Eurosec PR5208 Mains Flt after drilling through cable?

Hi Guys I have a Eurosec alarm in my apartment with a PR5208 control panel. About eight years ago when I moved in here I drilled through an alarm cable when installing some patio blinds. Since then t ... more

done

How to use/reset Eurosec PR5208?

Hi, I have moved into a house with a Eurosec PR5208 alarm fitted. At the moment it just says 'unset' but I have no instruction manual or code from the last tenants. Does anyone know how I could go a ... more

done

Can't set - lock out + use 6116 shows?

Could someone please help. I have a Eurosec alarm with PR5208 revision 1.1 keypad. The installer set it for yearly service which causes lock out! Unfortunately i cannot contact him any more so can ... more

done

pr5208 alarm is going off and i can't stop it?

my eurosec pr5208 house alarm is going off and i don't have the code to stop it, what can i do?

done

one of my alarm sensors is constantly flashing?

I have a Eurosec PR5208 rev 1.0. I can't set the system without deleting that zone each time. the sensor is constantly flashing as though spotting an intruder. it is very frustrating. Could I reset t ... more

done

resetting from fault with mains?

The eurosec pr5208 Rev 1.0 panel is showing that there has been a mains fault- check. There is nothing wrong with the mains but I need to reset. I do not know the previous users code. I have tried eng ... more

done

Re set codes?

I have an Eurosec PR5208 alarm system and I want to know how to cancell existing codes and insert new codes.

eorosec reset,home alarm systems?

can anyone tell me how to reset a EUROSEC PR5208 REV1.0 ? for my mother in law .the last tennant had it installed then just left without leaving the code.many thanks for any help...

done