Michael asked ... Mountfield empress drive belt?    |    John Barton asked ... How do i clear the TAM?    |    John asked ... How can I mend my binatone veva 1210 handset?    |    Kurt asked ... How can i mend my Aiwa HV-FX7700K?    |    Laetitia asked ... Toyota overlocker model 3400 D?    |    Click here to ask your question

How do I clear error code E00 on Bosch maxx 6 washing machine?

Have error code E00 constant but not flashing. How can I clear this. I have switched it off at mains and held down the pause/stop button.
Shirley lawson, June 2015
I used Gwyn's advice to clear error coded E16. Thanks. All the other sites said replace £80 Board. ;)

Namib, October 2021
thank u gwyn

calvin, May 2021
It means overloaded when you put too many items in machine, and when it soaks in water it makes too heavy for a spinner. to protect bearings and belts sensors will stop operation, letting you open door to remove some or all items.
Sorry I do not have experience 30+ years but it easy to work out, especially with your expirience ...

geo, July 2020
I do I clean an Error E:00 in a Siemens machine wash and dry IQ700
It seems related to excess of foam, but the programme ended.

João, May 2020
Merci beaucoup ..... enfin un site qui donne des vraies solutions!!!
De plus la procédure fonctionne aussi sur un Bosch maxx7 varioperfect!
Thank a lot
Un frog qui vous veut du bien!!
Simon

Simon, February 2018
I am not sure it works for every Bosch washer.
In my case I keep pushing the start button and turned nob around.
When the nob was set in perm press heavy soil, my machine was started to work normally .
I recommend to stay each menu at least 2 second with pushin start button at the same time.
Hope it works out for you.

Henry Kim, December 2017
this also solve my problem on Bosch maxx 7

Hassan, July 2017
Just had this on machine less than 2 years old. Bosch engineer had never seen it before and couldn't find a fault but said to clear it push and hold the start button while switching the knob from off to the 1st position left [easy care 30]. Hold for a few seconds until "888" is displayed. Turn knob back to "off" and display should be back to normal.

Gwyn, July 2016
link Click here to see other fixes for Bosch Maxx 6.