I have error code C9 motor issue displayed on the LED front screen. I can reset this ok using the sequence of pressing the buttons, but, after 5 minutes, the error reappears. I have replaced the motor and also brushes, but exactly the same issue appears. The motor spins for 2 seconds and then gently comes to a rest. I'm now suspecting a fault with the electronics PCB located at bottom RHS of rear belt assembly since the PCB has a motor controller relay and suspect that this may be where the fault lies. Perhaps the relay is not energizing for long enough due to a faulty capacitor in the circuit. Any ideas most welcome. Thanks

Mark, September 2015

Could be wiring or connectoirs. See http://www.justanswer.com/uk-appliance/3n1in-hi-aeg-oko-lavamat-72620-washing-machine-showing.html

and

http://tips.negaard.net/tips/AEG_Reset.html

Also

http://mr-ives.blogspot.co.uk/2009/01/replaing-brushes-in-aeg-lavamat-72620.html

XXXXX, September 2015