1.... check the wands and nozzle by looking through them at a bright light. Should be unobstructed.
2......remove cap that says wait 5 minutes and fill with water. You can go up to the bottom of the threads to the cap,
3........plug in and switch on, the swich should glow red.
4........wait for water to heat up and start steaming out of the nozzle.
5........if you want to quit before all the steam is exhausted switch off, pop off the end nozzle and let the steam go until it runs out.
6...... the ek-8005 which I have was design patented by Chun Ming Chen D522,195 at USPO.
7.......to prevent scale buildup use 50/50 mix of white vinegar occasionally.
8...... grease the cap threads with plumber's lube, the silicone one works best. You can use vaseline too, main thing is to keep the cap from getting frozen from corrosion.
I got this mine 2nd hand without instructions too, but it is after all just a boiler.
frank, January 2007
