How to omit zones 3 and 4 in an unset time period

Julie Penn, May 2007

Diane
It could be a fault on the exit zone so this is why it keeps bleeping.

steve, August 2012

Not getting any responce when pressing my keypad

steve, August 2012

after disconnecting power supply, the alarm sounded and went quiet, when power reconnected alarm could not be reset.
power to device light is still on.

DENNIS ROGERS, January 2012

Oi pessoal!
Agradecia de antemão, se houver por aí­ uma alma caridosa, que me possa ajudar.
Tenho um alarme Optima XM, que está parado há 10 anos. Já comprei as baterias para substituir as velhas. Mas como já não me lembro do código, não consigo que funcione. Ligo-o e começa logo a berrar. Já tentei introduzir o código de fábrica, mas continua a berrar. O que poderei tentar fazer mais??? Se alguém aí me puder ajudar agradecia sinceramente. Obrigado...

L. Fraga, April 2011

When I set my alarm it continues to make a noise and does not cut off when I leave the house. It used to beep for about 30 secs still we cleared the house but now it just keeps on beeping. Feel there must be a simple solution

Diane, September 2009

Omitting a zone, clear or in fault may be done by during the exit period. Pressing the OMIT button will change the exit tone to an omit tone, pressing 0 resets any false
selections, pressing 2 selects zone two etc. The relevant zone indicators will now flash to show the zones which are about to be turned off. When selection is complete, press the set button and the exit tone will continue. A maximum of three of the four zones may be omitted in this way.

Pete, May 2007