Hi, I hope some one can help. I Have replaced an existing alarm with a Veritas8 Compact. The SAB is the Gardtech Novagard 2. As an existing system I connected the Veritas 8 to the 6 zoned PIR's and the SAB. I wired exactly as per the Installation Manual. When I connect the internal SAB battery the bell produces an alarm signal, the alarm does not activate untill I connect this battery. Also I can create a tamper on the Panel which causes an alarm activation without the battery connected. Any advice would be much apprecaiated,

Marko

Marko, September 2007

I did a complete check in engineer mode, walk test 06 with bell box connected and cover fitted, 9 beeps with tamper error shown. On pressing omit(extended display)zone 1 lit meaning bell tamper error. I tried same test with bell box disconnected and no error shown.I think that I need a new bell box unless anyone knows different.

marko, September 2007