i need a parts list and plan of an old westwood s600?

i am trying to repair a westwood s600, i have all of the parts but i need to see a drawing of how it all goes together, so i get the right bits in the right place. do you know where i can get one

done

I need to know how to get the starter wheel for the rope apart to replace?

the spring wire ? (It is a Murray push mower).

done

snapper riding mower won't go foward?

how do I adjust the clutch

done

How can I fix my lawn mower that hasn't been used in a year?

My lawn mower hasn't been used in over a year and now it won't even start. What should I do? It is a Murray 20" 3.5 hp Classic. I don't know anything about mowers except how to use one.

done

Atco Royal B24 -HELPPP - clutch is kaput?

There are 3 plates with 3 bands between each - so its playe band plate band etc. the middle band disintegrated! - I tapped and prised it out without doing any damage to anything else - of course now ... more

done

want move?

My snapper rider want move when I release the clutch. It just sits there and you can feel a nudging movement, like it wants to move.

done

How much damage can 6.5hp briggs mower have after running over tennis ball?

Just after buying a new Troy Built 6.5hp push behind mower w/bagger there was a tennis ball in the grass I did not see. After running over it the mower does nothing more than start & die. I pulled t ... more

done

briggs and stratton push mower - springs?

I had to take of the gas tank because it was broken - so i replaced it and now have to put the two springs on (1 big 1 little) but i don't know where they go. Thanks Maybe you could send a diagra ... more

done

How to remove engine pulley?

I have a Craftsman rider with a blown 12.5 Techumseh. How do you remove the engine pulley from the shaft for installation on new engine.

done

lawn mower speed varies from high to low (carb. been clean)?

how do i fix my mower. my carbs. been cleaned and new filter. my speed levers broke, but never had a problem mowing last year. my mowers speed varies from high to low, and sometimes cuts out.

done

My riding mower won't start?

How can I get my riding mower to start? It has fresh gas, good spark plugs...even tried to jump it off. What else can it be? It's a John Deere, unsure of year or model. I bought it used from a friend ... more

done

engine surges then stops?

We have a 3 year old Toro GTS personal speed mower. When it starts up the engine speed will alternate bewteen very fast/skow and then quit. I am *totally* ignorant about engines but it seems that the ... more

done

what kind of oil is recommended for snapper 4 hp mower?

what oil is recommended for snapper 4 hp engine

done

how to replace a mower belt?

my belt broke and i dont know how to replace it

done

wiring diagram mtd lawn tractor?

where do i find a wiring diagram for mtd 131-800h0001a22181

done

B&S PULLSTART LAWNMOWER STALLING OUT?

My lawnmower a Briggs and Stratton 5 HP, after primed runs for about 5-10 seconds, then stalls out. We cleaned the carb bowl out, drained old gas, cleaned air filter and checked the spark plug. Now i ... more

done

The sparkplug lead is rusty, How do you change it?

The sparkplug lead on my mower is rusty. how do I go about changing it?

done

how to install belt on deck?

murry victa 4216 hy16.5 hydra dr how to install belt that drives cutting blades thanks Bruce

done

How can I keep the belt from coming off?

I just replaced the belt that runs the blade on my Snapper riding mower. The belt keeps vibrating off the pulley, and the blade stops. How can I fix this? Can I increase the belt tension so the belt d ... more

done

How can I fix my Sears 3.5 hp 20" gas mower?

My Sears mower after priming keeps cutting out and dying, what can I do to fix the promblem?

done