Veritas 8?

unset light flashing and will not reset

done

Reset alarm?

we have just moved into a bungalow and we do not know code for the alarm previous tenant has died so we don't know alarm code or how to reset it we pressed the panic button and set alarm off and had t ... more

done

Veritas 8 alarm?

veritas 8 went off battery dead replaced and alarm just keeps going off and wont reset

done

Rover 25, 1.4, 52 plate?

I have a rover 25 1.4 52 plate . I have had to have a new battery for my car as i havent been able to drive it for 5 months. I am having problems with the immobiliser and how to disarm it so i can sta ... more

Mend alarm?

Optima XM - the alarm went off when there was a power cut. Incorrectly put the wrong code in at first but now the tamper light on. How can I get it off

Burglar alarm?

re CP8L LCD When the mains is switched off off the outside alarm sounds - how can I override this - so I can do electrical jobs.

done

How can i mend my sercurit 700plus?

The keypad on my securit 700l plus is faulty. I need to press in the entry code twice before it accepts the code. SECURIT 700L Plus - C031 096 03. Can it be rectified or do I need to purchase a ne ... more

Optima 2plus home security alarm?

I have a Optima 2plus home security alarm, how do I extend wiring that has been snapped?

Intruder Alarm Citadel XR2?

Citadel XR2 Intruder Alarm. My alarm occasionally makes a low level croaking sound from the external wall mounted unit. It happens for about 20 mins then stops then is OK for about a week or more. ... more

How can i mend my scantronic 9448 alarm?

my scantronic 9448 has 2 panic alarms in different bedrooms. whilst redecorating one, the now rarely used spare bedroom, i decided this panic button was no longer needed and [ perhaps foolishly in ret ... more

Home alarm probl?

eurosec cp8l lcd the panel sis showing Check! I can't seem to change anything

Alarm?

scantronic i-on16 reading jamming present

done

Bell box wiring?

Help please. how do i wire a Odyssey 1e bell box to the Pyronix euro 46 control panel.

Optima XM6 without back up battery?

Can you operate an Optima XM6 alarm system without a back up battery? I don’t want the alarm to keep going off when there is a power cut.

SR system reset on Scantronic 9827 after total power failure?

How do i reset a SR code (system Reset) on scantronic 9827

done

Logic 4 home alarm?

logic 4 barrel control, where would i get a replacement , key just turns but will not arm

How can I reset my alarm?

my accenta/optima G 4 in tamper fault and lock out mode. I cannot reset .When in walk test it has a constant alarm and all zones are in 0. I tried factory default but still no good.

How can I repair my Melcom ST6500?

Melcom ST 6500. While replacing PIR sensors, I accidentally shorted two wires setting off alarm. Had to turn of mains and disconnect battery briefly to stop alarm. Sensors are responding to movement, ... more

Tamper sensor when decorating?

Decorator is stripping a room tomorrow our alarm is controlled by an Accenta 8 mini. The room sensor will have to be removed which will activate tamper sensor the alarm will go of. What is the procedu ... more

Optima xl6?

Can you help I have a Optima XL 6 home alarm and one of my zones keeps making my alarm go off after I set it to go out

done