can i sew a repair to a bouncy castle ?

do i need to use an adhesive or special thread

done

how can i unseize an engine ?

engine is a 80hp ford 4 cylinder inboard on my motor cruiser.engine has seized due to lack of use .what is the best way to free it without stripping it down .

done

where do u put the oil, in 2hp marina outboard motor?

i had to take motor for repair as the propeller was jamed, the guy pulled it apart and soaked it to clean it , he said to me u need a rubber ring ,or just keep up with the oil after each use of motor ... more

done

mercury blue band, remote?

this may seem like a silly qustion but on the remote for the blue band, it's about 73 i think, there is the throttle and another lever i was wondering if ayone could tell me what that other lever is f ... more

How can I find a wiring schematic for a 70 hp ?

Yamaha precision blend 70TLRR 6H3 L 482689

how to free a zipper to work that has sea salt on it?

I have a bag with equipment in side it - that got wet with sea salt and it has a zipper that I cannot unzip. It has been setting for a couple of years. I have tried marvel oil and hot water. That doe ... more

done

Yamaha jetski FZR?

Hi, I have lose Remote security and low-RPM mode transmiter for my Yamaha 2010 FZR. Yamaha servise want 2000 usd for new transmitter programing. I can buy new reciver and transmitter for 1200 USD. ... more

yamaha 115 96 alarms?

i have an alarm that comes on occasionally but not sure of the meaning off the symbol it is a red circle with a line at the botom. Alarm goes off after turning motor off for a few mins

my sea doo gti wont run in water but is good out of water?

my sea doo runs fine out of water but when you put it in the water it stalls

done

sims super v windscreen?

i am trying to restore a sims super v she needs a lot of T.L.C but number one on the list is a new windscreen but i can not find one can any one help .thanks

done

how can i fix my clinker built boat?

how can i replace the rotten hull planking on my 26foot 1950s clinker built cruiser

Honda 10hp four stroke outboard...Mikuni oil pump???

On our engine there is round, factory sealed Mikuni oil- pump just behind the carb (and towards the back) with a pipe to the carb> What is the pump for and is it safe to run the engine without it?

seadoo sp 650 ?

hi my seadoo sp 650 will not go i was out in sea water and when i started the engine sand and rocks went into the back and jamed the propella i got the sand stones out but now it wont go fast it sta ... more

Mercury 500 50hp serial no 2519197 stalling under load?

I have an older Mercury 500 50 hp 2 stroke which has been standing for some time. It was tested in a tank and ran fine. Taken out today and starts idles fine the revs come up on the hand throttle. ... more

8hp yanmar diesel has power but wont turn over?

motor wont turn over , it has power to the ignition switch then nothing

done

how to fix mercury 50 2-stroke dilema?

mate has a 50hp mercury 2-stroke (oldish model) that a mechanic says has a sticking valve(guessing powervalve?) that stops it from idling and once on water underload does not make smooth power.quoted ... more

done

How do I improve the water output from my Mariner 20 outboard 2 Stroke?

I have a Mariner 20 hp 2 stroke outboard the water pump is fine but the spout although plenty of water comes out stops for a few seconds then is OK again.

done

does not run at full throttle?

will run fine at 70%of throttle but bogs down at full?

done

windscreen?

I need a windscreen for micro plus 501 can anyone help, and can anyone tell me dose the micro plus 501 take a long or short shaft engine cheers Joe

90's sea doo spx bombardier?

it has set up for sometime, tried to start it ,will crank ok and will run a little time if i spray starter fluid in carb , but won't hit a lick on it's own . can somebody give me some advice on what m ... more

done