I need to re-route the control panel to bellbox cable on my eurosec CPL8, is it as simple as I think it might be'
I will have to remove the old cable and replace with a new one'
Are there any pitfalls?

Alexander, August 2012

Many thanks for that, e manno.
Sounds a bit too technical for me, reckon I'll just have to get the installer out.
Thanks again.

Alexander, August 2012

Only pitfalls I can see, are those created by yourself,largest one being, not being able to clear the tamper and reset the system.

Meaning, if the tampers are set on engineering, do you know the code?, if not then you may have to get the installer in or locate another engineer.

If you can access engineering and have full control of your system, then leave the panel in ENG mode and undertake the work, or if you prefer you can shut the whole system down.

Have a copy of the engineering manual at hand and fully test the system on completion of the work.

Maybe worth replacing the battery in the outside sounder whilst you are up there.

e manno, August 2012