My Bosch diswasher Model 7710 is not cleaning or drying properly. I have tried a finish cleaner & it has not melted the wax top, which makes me think it is not heating up properly. does anyone know if this model has a heater/thermostat that can be replaced.

chris smith, September 2007

Hi, sounds like the control module fault ......an over heated pin in the centre of the cicuit board will be black with soot and will need re-soldering. Open door and remove top six screws, pull up and out plastic top panel. After soldering pin ....water will start to heat up. If further problems persist a new module will be needed ......refubished ones are half cost of new! Cheers, Bob.

Bob, November 2007