How can i mend my scantronic 9448 alarm?

my scantronic 9448 has 2 panic alarms in different bedrooms. whilst redecorating one, the now rarely used spare bedroom, i decided this panic button was no longer needed and [ perhaps foolishly in ret ... more

Home alarm probl?

eurosec cp8l lcd the panel sis showing Check! I can't seem to change anything

Alarm?

scantronic i-on16 reading jamming present

done

Bell box wiring?

Help please. how do i wire a Odyssey 1e bell box to the Pyronix euro 46 control panel.

Optima XM6 without back up battery?

Can you operate an Optima XM6 alarm system without a back up battery? I don’t want the alarm to keep going off when there is a power cut.

SR system reset on Scantronic 9827 after total power failure?

How do i reset a SR code (system Reset) on scantronic 9827

done

Logic 4 home alarm?

logic 4 barrel control, where would i get a replacement , key just turns but will not arm

How can I reset my alarm?

my accenta/optima G 4 in tamper fault and lock out mode. I cannot reset .When in walk test it has a constant alarm and all zones are in 0. I tried factory default but still no good.

How can I repair my Melcom ST6500?

Melcom ST 6500. While replacing PIR sensors, I accidentally shorted two wires setting off alarm. Had to turn of mains and disconnect battery briefly to stop alarm. Sensors are responding to movement, ... more

Tamper sensor when decorating?

Decorator is stripping a room tomorrow our alarm is controlled by an Accenta 8 mini. The room sensor will have to be removed which will activate tamper sensor the alarm will go of. What is the procedu ... more

Optima xl6?

Can you help I have a Optima XL 6 home alarm and one of my zones keeps making my alarm go off after I set it to go out

done

How do i increase the keyboard sounds and exit entry sounds?

Optima XM6 .Replaced battery recently. Since then the keyboard sounds have gone very quiet, and similar when arming system and entering the building. How do i increase the volume . When i have the c ... more

done

How can I stop beeping?

Scantronic 9427 Alarm has been beeping since 4am neighbours not too impressed I replaced the battery and typed in my code no red lights on panel but it still beeps every 10 to 15 mins Please help ... more

done

On Logic 4 alarm circuit box cut to reset?

On Logic 4 alarm panel box circuit Board why does it have cut for Auto reset , What does this mean, What dose it do if I cut it, It is not cut at the moment What will happen if I cut it,

done

First time set up of our Altex pr5208?

How do i do a first time set up of my alarm please

done

Replace alarm keypad?

The buttons on my Compact SL house alarm keypad are getting very hard to press. I can't find the SL keypad but could I use a different one? The Accenta G3 keypad looks exactly the same apart from wher ... more

Veritas 8 alarm will not unset?

Veritas 8 alarm sets ok but on entry and punching in code it will not unset so we have one green light and a live system. Tried reset but wont work

Eurosec pr5208?

Eurosec pr 5208 remote keypad, how to reset check kp tamper? I re-positioned the keypad with the voltage present (12v) now will not reset.

Swann cctv?

Can any one help have purchased a swann cctv system and need to change the password as the person i got it from lost it how do i go about resetting it

done

House Alarm continuously ringing?

Have Logic 4 Alarms Can I stop it continuously ring when it goes off How to make it just go off for 20 Minutes not continuous

done