how will i remove the clicking sound between the tub and its outer shell?

got a daewoo washing machine model dwf-1300SZ. it's still in good condition, but lately whenever the machine starts its spinning process to remove the water, there's a clicking sound between the tub a ... more

done

how to mend a kenmore vacuum?

the rotating brush is not turning so it may be a belt problem but how do you get to the belt? Kenmore progressive 12 amp vacuum.

done

Heater element or somthing like that has failed?

I have a Creda Reversair tumble dryer It has a heat select rocker switch of high or low. It was brand new about 18 months ago. It would appear that we're not getting any low or high heat. I've managed ... more

done

Why my Hotpoint Washing machine is jumping and shaking like crasy?

Please can you help me with this question as my Hotpoint washing machine is jumping and shaking like crasy when i switch it on, it was working fine before for the last 5 years.

done

washing is still wet after the machine has finished?

i have a PHILCO washing machine, after the cycle has finished the washing is still wet.. the machine is not over full, all the pipes appear to be free from blockage and the i can hear the pump running ... more

done

Zanussi TC470 Belt keeps coming off, How do I stop it?

The green belt on the back of the drier keeps coming off. How do I prevent this from happening? Also, is there a trip switch for the heating element if it gets too hot as a result of the belt coming ... more

done

How can I reattach the power cord on a Dyson DC04 ?

The power cord has become detatched from the switch housing on my Dyson DC04. It should be a relatively simple job but how do I gain access to the switch terminals? I've tried to lever the housing ap ... more

done

how can i mend my washing machine?

how can i put the door seal rubber back on to the drum of my tricity bendix

done

How can I replace a Dyson DC04 motor?

I know I can buy a motor, but I am not certain how to stripdown the cleaner to get at the motor. Doe's anyone know of a repair manual.

done

Hotpoint Ultima 1200 Error E15?

What does error code E15 mean on a Hotpoint Untima 1200 Washing Machine mean?

done

freeing the fault codes?

on a dyson machine you can free fault codes by pressing two buttons what are they...this will save £85 call out charge.

done

How do I change drum belt on Hotpoint 9326?

I have a Hotpoint Reversomatic 9326 Aquarius drying System electric european style tumble dryer. It is about 10 years old. The belt broke. I bought two new ones, a pol 40 and a pol 52. Which one is co ... more

done

fitting new belt on Reverse Action Tumble dryer?

How do I fit the belt round the two spring rollers or where can I get hold of Manual to show me how. Model Hotpoint TC71 Ultima Condenser Dryer

done

how can I repair my tumble drier?

There is no heat produced by my hotpoint aquarius tumble drier ,I guess its either the thermostat or the heater where are these and how do I test them?

done

Hotpoint Aquarius 900 WM91 wont start cycle?

This machine made a loud 'cracking' sound and will not start cycle now. I thought it was the door interlock and replaced it but still nothing. If I bridge the neutral and control(?)(red wire that goes ... more

done

No heat in my TC470 Zanussi?

The drum spins, something gets hot at the back, but there is no heat in the drum. Can anyone help?

done

how do I fit a drive belt on a Creda reversair 37468 tumble drier?

Does anyone know how the drive belt on this drier fits round the pulleys? I have got the belt in position, but when I fit it onto the pulleys in the only obvious way, the drum does not rotate, and I ... more

done

how can i repair my washer?

zanussi FL1012 auto washer this will not take in water on any programme except f then it sops on rinses. worked fine until it was moved to new location.

done

My tumble dryer spins but does not heat?

I have a Whirlpool Inspirations Condenser, it turns as normal, but does not heat up at all.

done

Tumble Dryer Heats Up But Clothes Just Become Warm and Stay Damp. Why?

Hi, My Tumble Dryer turns and the back plate heats up but my clothes just get warm but stay damp. There is no obvious blockage in the vent tubes. What could be wrong?!?!

done